Ip rip send version [1 | 2 – ADTRAN 1000R Series User Manual
Page 1207
Command Reference Guide
VLAN Interface Config Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
1207
ip rip send version [1 | 2]
Use the ip rip send version command to configure the RIP version the unit sends in all RIP packets
transmitted on the interface. Use the no form of this command to restore the default value.
Syntax Description
1
Transmits only RIP version 1 packets on the interface.
2
Transmits only RIP version 2 packets on the interface.
Default Values
By default, all interfaces transmit RIP version 1 (the default value for the version command).
Applicable Platforms
This command applies to the NetVanta 300, 1000R, and 2000 Series units.
Command History
Release 1.1
Command was introduced.
Functional Notes
Use the ip rip send version command to specify a RIP version that overrides the version (in the Router
RIP) configuration. Refer to
for more information.
The AOS only transmits one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the VLAN interface to transmit only RIP version 2 packets:
(config)#interface vlan 1
(config-interface-vlan 1)#ip rip send version 2