Encapsulation frame-relay ietf – ADTRAN 1000R Series User Manual

Page 845

Text mode
Original mode

Command Reference Guide

Frame Relay Interface Config Command Set

61200510L1-35E

845

encapsulation frame-relay ietf

Use the encapsulation frame-relay ietf command to configure the encapsulation on a virtual Frame Relay
interface as IETF (RFC1490). Currently, this is the only encapsulation setting. Settings for this option must
match the far-end router’s settings in order for the Frame Relay interface to become active.

Syntax Description

No subcommands.

Default Values

By default, all Frame Relay interfaces use IETF encapsulation.

Applicable Platforms

This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.

Command History

Release 1.1

Command was introduced.

Usage Examples

The following example configures the endpoint for IETF encapsulation:

(config)#interface frame-relay 1

(config-fr 1)#encapsulation frame-relay ietf