Show hosts [verbose – ADTRAN 1000R Series User Manual
Page 193
Command Reference Guide
Enable Mode Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
193
show hosts [verbose]
Use the show hosts command to display information such as the domain name, name lookup service, a list
of name server hosts, and the cached list of host names and addresses on the network to which you can
connect.
Syntax Description
verbose
Enables detailed messaging.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 3.1
Functional Notes
The list below describes the fields contained in the host table:
•
Flags: Indicate whether the entry is permanent (P) or temporary (T) and if the entry is OK or expired
(EXP).
•
Age: Indicates the age of the entry.
•
Type: Shows the protocol type.
•
Address: Displays the IP address for the entry.
Usage Examples
The following example is sample output from the show hosts command:
>enable
#show hosts
Name/address lookup uses domain name service
DNS Proxy is disabled
Default domain is not set
Name servers are 1.1.1.1 2.2.2.2
Host
Flags
Age
Type
Address
Example1
(P OK)
- -
IP
1.1.1.1
Example2
(P OK)
- -
IP
2.2.2.2