ADTRAN 1000R Series - Manual (Page 1305)

Command Reference Guide Router (OSPF) Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1305
auto-cost reference-bandwidth
Use the auto-cost reference-bandwidth command to assign a different interface cost to an interface. It
may be necessary to assign a higher number to high-bandwidth links . This value is used in OSPF metric
calculations.
Syntax Description
Sets the default reference bandwidth rate (range: 1 to 4,294,967 Mbps).
Default Values
By default, the rate is set to 100.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 3.1 Command was introduced.
Usage Examples
The following example sets the auto cost reference-bandwidth to 1000 Mbps:
(config)#router ospf
(config-ospf)#auto-cost reference-bandwidth 1000