ADTRAN 1000R Series - Manual (Page 1024)

Command Reference Guide Port Channel Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1024
spanning-tree edgeport
Use the spanning-tree edgeport command to configure the interface to be an edgeport. This command
overrides the Global setting (refer to spanning-tree edgeport default
on page 518 ). Use the no version of
the command to return to the default setting.
Syntax Description
No subcommands.
Default Values
By default, this setting is disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1 Command was introduced.
Functional Notes
Enabling this command configures the interface to go to a forwarding state when the link goes up.
Usage Examples
The following example configures the interface to be an edgeport:
(config)#interface port-channel 1
(config-p-chan 1)#spanning-tree edgeport
An individual interface can be configured to not be considered an edgeport. For example:
(config)#interface port-channel 1
(config-p-chan 1)#spanning-tree edgeport disable
or
(config)#interface port-channel 1
(config-p-chan 1)#no spanning-tree edgeport