ADTRAN 1000R Series User Manual

Page 576

Command Reference Guide

BRI Interface Configuration Command set

61200510L1-35E

576

isdn switch-type [basic-5ess | basic-dms | basic-net3 | basic-ni]

Use the isdn switch-type command to specify the ISDN signaling type configured on the Basic Rate ISDN
(BRI) interface. The type of ISDN signaling implemented on the BRI interface does not always match the
manufacturer of the Central Office switch. Use the no form of this command to return to the default value.

Syntax Description

basic-5ess

Specifies Lucent/AT&T 5ESS signaling.

basic-dms

Specifies Nortel DMS-100 custom signaling.The basic-dms signaling type is not
compatible with proprietary SL-1 DMS signaling.

basic-net3

Specifies Net3 Euro-ISDN signaling.

basic-ni

Specifies National ISDN-1 signaling.

Default Values

By default, the ISDN signaling is set to National ISDN-1.

Applicable Platforms

This command applies to the NetVanta 1000R, 3000, and 4000 Series units.

Command History

Release 1.1

Command was introduced.

Functional Notes

The isdn switch-type command specifies the type of ISDN signaling implemented on the BRI interface,
not the manufacturer of the Central Office switch. It is quite possible to have a Lucent Central Office switch
providing National ISDN signaling on the BRI interface.

Usage Examples

The following example configures a BRI interface for a circuit with Lucent 5ESS (custom) signaling:

(config)#interface bri 1/2

(config-bri 1/2)#isdn switch-type basic-5ess