ADTRAN 1000R Series - Manual (Page 1327)

Command Reference Guide DHCP Pool Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1327
DHCP P OOL C OMMAND S ET
To activate the DHCP Pool mode, enter the ip dhcp-server pool command at the Global Configuration
mode prompt. For example:
>enable
#configure terminal
(config)#ip dhcp-server pool MyPool
(config-dhcp)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#>
on page 28
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
client-identifier on page 1328
client-name on page 1330
default-router on page 1331
dns-server on page 1332
domain-name on page 1333
hardware-address on page 1334
host on page 1336
lease on page 1337
netbios-name-server on page 1338
netbios-node-type on page 1339
network on page 1340
ntp-server on page 1341
option [ascii | hex | ip] on page 1342
tftp-server on page 1343
timezone-offset on page 1344