ADTRAN 1000R Series - Manual (Page 492)

Command Reference Guide Global Configuration Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 492
radius-server
Use the radius-server command to configure several global RADIUS parameters. Most of these global
defaults can be overridden on a per-server basis.
Variations of this command include the following:
radius-server challenge-noecho
radius-server deadtime
radius-server enable-username
radius-server key
radius-server retry
radius-server timeout
Syntax Description
challenge-noecho Turns off echoing of user challenge-entry. When echo is turned on, users
see the text of the challenge as they type responses. Enabling this option
hides the text as it is being entered.
deadtime Specifies how long a RADIUS server is considered dead once a timeout
occurs. The server will not be tried again until after the deadtime expires.
enable-username Specifies a username to be used for enable authentication.
key Specifies the shared key to use with a RADIUS server.
retry Specifies how many attempts to make on a RADIUS server before marking
it dead.
timeout Specifies how long to wait for a RADIUS server to respond to a request.
Default Values
challenge-noecho By default, echo is turned on.
deadtime 1 minute
key No default
retry 3 attempts
timeout 5 seconds
enable-username $enab15$
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.