ADTRAN 1000R Series - Manual (Page 605)

Command Reference Guide E1 Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 605
sa4tx-bit [0 | 1]
The sa4tx-bit command selects the Tx value of Sa4 in this E1 interface. Use the no form of this command
to return to the default value of 1.
Syntax Description
No subcommands.
Default Values
The default value for this command is 1.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 6.1 Command was introduced.
Functional Notes
This command assigns a value to the Tx spare bit in position 4. The odd-numbered frames of TS0 are not
used for frame alignment. Bits in position 4 through 8 are called spare bits. Values of 0 or 1 are accepted.
Usage Examples
The following example sets the Tx value of Sa4 to 0:
(config)#interface e1 1/1
(config-e1 1/1)#sa4tx-bit 0
TS0 odd frame
Bit position 1 2 3 4 5 6 7 8
Bit use 0 1 RAI = 1 S S S S S