ADTRAN 1000R Series - Manual (Page 1260)

Command Reference Guide IKE Policy Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1260
IKE P OLICY C OMMAND S ET
To activate the IKE Policy mode, enter the crypto ike policy command at the Global Configuration mode
prompt. For example:
>enable
#configure terminal
(config)#crypto ike policy 1
(config-ike)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#>
on page 28
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
attribute on page 1261
client authentication host on page 1262
client authentication host xauth-type [generic | otp | radius] on page 1263
client authentication server list on page 1264
client configuration pool on page 1265
initiate [main | aggressive] on page 1266
local-id [address | asn1-dn | fqdn | user-fqdn] on page 1267
nat-traversal [allow | disable | force] on page 1269
peer [ | any] on page 1270
respond [main | aggressive | anymode] on page 1272
For VPN configuration example scripts, refer to the technical support note
Configuring VPN located on the ADTRAN OS Documentation CD provided with your
unit.