ADTRAN 1000R Series - Manual (Page 1007)

Command Reference Guide Loopback Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1007
ip rip send version [1 | 2]
Use the ip rip send version command to configure the RIP version the unit sends in all RIP packets
transmitted on the interface.
Syntax Description
1 Transmits only RIP version 1 packets on the interface.
2 Transmits only RIP version 2 packets on the interface.
Default Values
By default, all interfaces transmit RIP version 1 (the default value for the version command).
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 1.1 Command was introduced.
Functional Notes
Use the ip rip send version to specify a RIP version that overrides the version (in the Router RIP)
configuration.
The AOS only transmits one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the loopback interface to transmit only RIP version 2 packets:
(config)#interface loopback 1
(config-loop 1)#ip rip send version 2