ADTRAN 1000R Series - Manual (Page 822)

Command Reference Guide Demand Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 822
ip route-cache
Use the ip route-cache command to enable fast-cache switching on the interface. Use the no form of this
command to disable fast-cache switching and return to process switching mode.
Syntax Description
No subcommands.
Default Values
By default, fast-cache switching is enabled on all Ethernet and virtual Frame Relay sub-interfaces. IP route
cache is enabled for all virtual demand interfaces.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 2.1 Command was introduced.
Release 11.1 Command expanded to include the demand interface.
Functional Notes
Fast-cache switching allows an IP interface to provide optimum performance when processing IP traffic.
Usage Examples
The following example enables fast-cache switching on the virtual demand interface:
(config)#interface demand 1
(config-demand 1)#ip route-cache
Using Network Address Translation (NAT) or the AOS firewall capabilities on an interface
requires process switching mode (using the no ip route-cache command).