ADTRAN 1000R Series - Manual (Page 1013)

Command Reference Guide Port Channel Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1013
P ORT C HANNEL I NTERFACE C ONFIG C OMMAND S ET
To activate the Port Channel Interface Configuration mode, enter the interface port-channel command at
the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface port-channel 1
(config-p-chan 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#>
on page 28
description on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
arp arpa on page 1014
lldp receive on page 1015
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive]
on page 1016
qos [trust cos | default-cos ] on page 1018
snmp trap on page 1019
snmp trap link-status on page 1020
spanning tree commands begin on page 1021
storm-control [broadcast level | multicast level | unicast level] on page
1027
storm-control action [shutdown] on page 1029
switchport commands begin on page 1030