ADTRAN 1000R Series - Manual (Page 16)

Command Reference Guide Basic Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 16
B ASIC M ODE C OMMAND S ET
To activate the Basic mode, simply log in to the unit. After connecting the unit to a VT100 terminal (or
terminal emulator) and activating a terminal session, the following prompt displays:
>
The following command is common to multiple command sets and is covered in a centralized section of
this guide. For more information, refer to the section listed below:
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
enable on page 17
logout on page 18
ping on page 19
show clock on page 21
show snmp on page 22
show version on page 23
telnet on page 24
traceroute on page 25