ADTRAN 1000R Series - Manual (Page 1265)

Command Reference Guide IKE Policy Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1265
client configuration pool
Use the client configuration pool command to configure the AOS to perform as mode-config server (edge
device) when an IKE policy is negotiated.
Variations of this command include the following:
client configuration pool <poolname>
client configuration pool <poolname> initiate
client configuration pool <poolname> initiate respond
client configuration pool <poolname> respond
client configuration pool <poolname> respond initiate
Syntax Description
The pool from which to obtain parameters to assign to the client.
Default Values
By default, if this command is not present in the IKE policy, the ADTRAN device allocates mode-config IP
addresses, DNS server addresses, and NetBIOS name server addresses, and mode-config is not
performed.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1 Command was introduced.
Functional Notes
This command ties an existing client configuration pool to an IKE policy.
Usage Examples
The following example ties the ConfigPool1 configuration pool to this IKE policy:
(config-ike)#client configuration pool ConfigPool