Qos map Page 488
Page 488
Command Reference Guide
Global Configuration Mode Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
488
qos map
Use the qos map command to activate the QoS Map Command Set (which allows you to create and/or edit
a QoS map). For details on specific commands, refer to the section Quality of Service (QoS) Map
Commands
. Use the no form of this command to delete a map entry.
Syntax Description
Specifies the QoS map name.
Specifies a number (valid range: 0 to 65,535) to differentiate this QoS map and to
assign match order.
Default Values
No default value is necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 6.1
Command was introduced.
Functional Notes
A QoS policy is defined using a QoS map. The QoS map is a named list with sequenced entries. An entry
contains a single match reference and one or more actions (priority, set, or both). Multiple map entries for the
same QoS map are differentiated by a sequence number. The sequence number is used to assign match order.
Once created, a QoS map must be applied to an interface (using the qos-policy out
command) in order to actively process traffic. Any traffic for the interface that is not sent to the priority
queue is sent using the default queuing method for the interface (such as weighted fair queuing).