ADTRAN 1000R Series - Manual (Page 506)

Command Reference Guide Global Configuration Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 506
snmp-server host
Use the snmp-server host traps command to specify traps sent to an identified host. Use multiple
snmp-server host traps commands to specify all desired hosts. Use the no form of this command to return
to the default value.
Syntax Description
Specifies the IP address of the SNMP host that receives the traps.
Specifies the community string (used as a password) for authorized agents to
obtain access to SNMP information.
Specifies the type of notification trap to enable. Leaving this option blank enables ALL
system traps.
snmp Optional. Enables a subset of traps specified in RFC1157.
The following traps are supported:
coldStart
warmStart
linkUp
linkDown
authenticationFailure
Default Values
By default, there are no hosts or traps enabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Usage Examples
The following example sends all SNMP traps to the host at address 190.3.44.69 and community string
My Community:
(config)#snmp-server host 190.3.44.69 traps My Community snmp