ADTRAN 1000R Series - Manual (Page 160)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 160
show atm [pvc | traffic] interface atm
Use the show atm command to display information specific to the asynchronous transfer mode (ATM)
interface.
Variations of this command include the following:
show atm pvc
show atm pvc interfaces atm
show atm traffic interface atm
Syntax Description
pvc Displays ATM PVC information.
traffic Displays ATM traffic information.
Displays the ATM PVC information, for the specified sub-interface (x.x) number.
Displays the ATM port traffic information, for the specified ATM port number
(valid range: 1 to 1023).
Displays the ATM VCL traffic information, for the specified ATM VCL number
(valid range: 1 to 1023).
Default Values
No default is necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, and 4000 Series units.
Command History
Release 8.1 Command was introduced.
Usage Examples
The following is sample output from this command:
>enable
#show atm pvc interface atm 1.1
Encap Peak Avg/Min Burst
Name VPI VCI Type SC Kbps Kbps Cells Status
atm 1.1 0 200 SNAP N/A 0 0 0 Active