ADTRAN 1000R Series - Manual (Page 717)

Command Reference Guide ATM Sub-Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 717
ATM S UB -I NTERFACE C ONFIG C OMMAND S ET
To activate the ATM Interface Configuration mode, enter the interface atm command (and specify a
sub-interface) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface atm 1.1
(config-atm 1.1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#>
on page 28
description on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy on page 718
bandwidth on page 722
bridge-group on page 723
crypto map on page 724
dial-backup commands begin on page 726
dynamic-dns [dyndns | dyndns-custom | dyndns-static]
on page 742
encapsulation [aal5mux | aal5snap] on page 744
fair-queue on page 745
hold-queue out on page 746
ip commands begin on page 747
max-reserved-bandwidth on page 769
mtu on page 770
oam retry on page 771
oam-pvc managed on page 772
pvc on page 773
qos-policy out on page 774
spanning-tree commands begin on page 776