ADTRAN 1000R Series User Manual

Page 301

Command Reference Guide

Enable Mode Command Set

61200510L1-35E

301

Usage Examples

The following example displays the configuration of the switch stack while in stack-master mode:

>enable

#show stack

Stack mode is MASTER

Management Vlan is 2386, firmware version is 08.00.18.D

Stack network is 169.254.0.0/24

Stack members...

Member

stack member's Unit ID

MAC address

stack member's MAC address

Mgmt IP Address

stack member's IP address

Source Interface

interface that the stack member was learned from

State

Up (member is up and functioning properly); Down (member was at one time
functioning, but we have lost contact with it); Waiting (we are waiting for the unit
to register with us; when he does, we will add it to the stack); Denied (the unit
could not be added to the stack because the stack protocol versions were not
compatible).

The following example displays the configuration of the switch stack while in stack-member mode:

>enable

#show stack

Stack mode is STACK-MEMBER

My Unit ID is 3, management Vlan is 2386

Stack management network is 169.254.0.0/24

Stack Master info:

Master is "Switch", learned via giga-eth 0/1

IP address is 169.254.0.1, MAC address is 00:DE:AD:00:65:83

The following example displays all units that have registered with this stack-master.

Member

Mac Address

Mgmt IP Address

Source Interface

State

00:A0:C8:02:CF:C0 169.254.0.2

Stack

port

00:A0:C8:00:8C:20

169.254.0.3

Stack port