ADTRAN 1000R Series - Manual (Page 219)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 219
show ip community-list []
Use the show ip community-list command to display any or all defined community lists in the router
configuration.
Syntax Description
Optional. Specifies the name of the community list you wish to display. If this
parameter is omitted, all defined community lists will be displayed.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 10.1 Command was introduced.
Usage Examples
The following example shows two community lists, one of which permits all routes containing community
number 10:67, and another which permits routes containing community number 10:68 and the internet
community number, but denies routes containing community number 10:45.
NetVanta4305#show ip community-list
ip community-list CommList1:
permit 10:67
ip community-list CommList2:
permit 10:68 internet
deny 10:45