Ip ospf – ADTRAN 1000R Series User Manual
Page 1001
Command Reference Guide
Loopback Interface Configuration Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
1001
ip ospf
Use the ip ospf command to customize OSPF settings (if needed).
Syntax Description
authentication-key
Specifies a simple-text authentication password to be used
by other routers using
password authentication.
cost
Specifies the OSPF cost of sending a packet on the interface.
This value overrides any computed cost value.
Range: 1 to 65,535.
dead-interval
Sets the maximum interval allowed between hello packets. If
the maximum is exceeded, neighboring devices will
determine that the device is down. Range: 0 to 32,767.
hello-interval
Specifies the interval between hello packets sent on the
interface. Range: 0 to 32767.
message-digest-key
Configures OSPF Message Digest 5 (MD5) authentication
(16-byte max) keys.
priority
Set the OSPF priority. The value set in this field helps
determine the designated router for this network.
Range: 0 to 255.
retransmit-interval
Specifies the time between link-state advertisements (LSAs).
Range: 0 to 32,767.
transmit-delay
Sets the estimated time required to send an LSA on the
interface. Range: 0 to 32,767.
Default Values
retransmit-interval
5 seconds
transmit-delay
1 second
hello-interval
10 seconds: Ethernet, point-to-point, Frame Relay, and PPP
dead-interval
40 seconds
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 3.1
Command was introduced.