ADTRAN 1000R Series - Manual (Page 676)

Command Reference Guide Serial Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 676
S ERIAL I NTERFACE C ONFIGURATION C OMMAND S ET
To activate the Serial Interface Configuration mode, enter the interface serial command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface serial 1/1
(config-ser 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#>
on page 28
description on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
et-clock-source [rxclock | txclock] on page 677
ignore dcd on page 678
invert etclock on page 679
invert rxclock on page 680
invert txclock on page 681
serial-mode [eia530 | v35 | x21] on page 682
snmp trap on page 683
snmp trap link-status on page 684