ADTRAN 1000R Series - Manual (Page 782)

Command Reference Guide Demand Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 782
D EMAND I NTERFACE C ONFIGURATION C OMMAND S ET
To activate the Demand Interface Configuration mode, enter the interface demand command at the
Global Configuration mode prompt. For example:
#configure terminal
(config)#interface demand 1
(config-demand 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#>
on page 28
description on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy on page 784
bandwidth on page 787
called-number on page 788
caller-number on page 789
connect-mode [answer | originate | either] on page 790
connect-order [last-successful | round-robin | sequential] on page 791
connect-sequence on page 792
connect-sequence attempts on page 794
connect-sequence interface-recovery [retry-interval | max-retries ] on
page 795
crypto map on page 796
demand-hold-queue timeout on page 798
dynamic-dns [dyndns | dyndns-custom | dyndns-static]
on page 799