ADTRAN 1000R Series - Manual (Page 36)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 36
E NABLE M ODE C OMMAND S ET
To activate the Enable mode, enter the enable command at the Basic mode prompt. (If an enable password
has been configured, a password prompt will display.) For example:
>enable
Password: XXXXXXX
#
The following command is common to multiple command sets and is covered in a centralized section of
this guide. For more information, refer to the section listed below:
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
clear commands begin on page 38
clock auto-correct-dst on page 80
clock no-auto-correct-dst on page 81
clock set on page 82
clock timezone on page 83
configure [memory | network | overwrite-network | terminal] on page 86
copy on page 87
copy console on page 88
copy flash on page 89
copy interface on page 90
copy tftp on page 91
copy xmodem on page 92
debug commands begin on page 93
dir on page 146
dir [ | flash | flash ] on page 147
disable on page 148
enable on page 149
erase [ | startup-config] on page 150
events on page 151
exception report generate on page 152
logout on page 153
ping on page 154
ping stack-member on page 156
reload [cancel | in ] on page 157