ADTRAN 1000R Series - Manual (Page 1270)

Command Reference Guide IKE Policy Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1270
peer [ | any]
Use the peer command to enter the IP address of the peer device. Repeat this command for multiple peers.
Use the any keyword if you want to set up a policy that will initiate or respond to any peer.
Syntax Description
Specifies a peer IP address.
any Allows any peer to connect to this IKE policy.
Default Values
There are no default settings for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1 Command was introduced.
Functional Notes
An IKE policy is incomplete unless one of the peer commands is specified. Only one IKE policy can be
configured with peer any.
Usage Examples
The following example sets multiple peers on an IKE policy for an initiate-and-respond policy using
pre-shared secret, DES, MD5, and Diffie-Hellman Group 1:
(config)#crypto ike policy 100
(config-ike)#peer 63.97.45.57
(config-ike)#peer 63.105.15.129
(config-ike)#peer 192.168.1.3
(config-ike)#respond anymode
(config-ike)#initiate main