ADTRAN 1000R Series User Manual
Page 300
Command Reference Guide
Enable Mode Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
300
show stack [candidates | candidates realtime | realtime | topology |
topology realtime]
Use the show stack command to view the status of all the switches configured for stacking.
Syntax Description
show stack
Displays the mode of the switch as either master or member. If the mode is
master, this command also gives the status of the stack members.
candidates
Displays all units that have registered with this stack master. This option is only
available on a switch configured as a stack master.
candidates realtime
Displays candidates output in real time.
realtime
Displays full-screen output in real time. See Functional Notes below for more
information.
topology
Displays the stack topology. This option is only available on a switch configured as
a stack master.
topology realtime
Displays the stack topology output in real time.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 1000 and 1000R Series units.
Command History
Release 8.1
Command was introduced.
Release 10.1
The real time display option was introduced.
Functional Notes
The stack candidates are a list of units that could be added to the stack. They are not yet members.
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to