ADTRAN 1000R Series User Manual

Page 856

Command Reference Guide

Frame Relay Interface Config Command Set

61200510L1-35E

856

frame-relay lmi-type [ansi | auto | cisco | none | q933a]

Use the frame-relay lmi-type command to define the Frame Relay signaling (LMI) type. Use the no form
of the command to return to the default value.

Syntax Description

ansi

Specifies Annex D signaling method.

auto

Automatically determines signaling type by messages received on the frame
circuit.

cisco

Specifies Group of 4 signaling method.

none

Turns off signaling on the endpoint. This is used for dial-backup connections to
ADTRAN IQ and Express series products.

q933a

Specifies Annex A signaling method.

Default Values

By default, the Frame Relay signaling type is set to ansi.

Applicable Platforms

This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.

Command History

Release 1.1

Command was introduced.

Release 2.1

Added signaling type none to provide support for dial-backup to ADTRAN IQ and
Express series products.

Usage Examples

The following example sets the signaling method for the endpoint to cisco:

(config)#interface frame-relay 1

(config-fr 1)#frame-relay lmi-type cisco