ADTRAN 1000R Series - Manual (Page 613)

Command Reference Guide Ethernet Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 613
E THERNET I NTERFACE C ONFIGURATION C OMMAND S ET
There are four types of Ethernet interfaces associated with the AOS:
• Basic Ethernet interfaces (e.g., eth 0/1)
• Gigabit Ethernet interfaces (e.g., giga-eth 0/3)
• Ethernet sub-interfaces associated with a VLAN (e.g., eth 0/1.1)
• Ethernet interface range (e.g., eth 0/1, 0/8)
To activate the basic Ethernet Interface Configuration mode, enter the interface ethernet command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface ethernet 0/1
(config-eth 0/1)#
To activate the Gigabit Ethernet Interface Configuration mode, enter the interface gigabit-ethernet
command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface gigabit-ethernet 0/3
(config-giga-eth 0/3)#
To activate the Ethernet Sub-Interface Configuration mode, enter the interface ethernet command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface ethernet 0/1.1
(config-eth 0/1.1)#
To activate the Ethernet Configuration mode for a range of Ethernet interfaces, enter the interface range
command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface range ethernet 0/1, 0/8
(config-eth 0/1, 0/8)#