ADTRAN 1000R Series - Manual (Page 298)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 298
show spanning-tree root [address | cost | detail | forward-time |
hello-time | id | max-age | port | priority | priority system-id]
Use the show spanning-tree root command to display information regarding the spanning-tree protocol
root.
Syntax Description
address Optional. Displays the address of the spanning-tree root.
cost Optional. Displays the path cost of the spanning-tree root.
detail Optional. Displays the spanning-tree root information in detail.
forward-time Optional. Displays the forward-time of the spanning-tree root.
hello-time Optional. Displays the hello-time of the spanning-tree root.
id Optional. Displays the ID of the spanning-tree root.
max-age Optional. Displays the maximum age of the spanning-tree root.
port Optional. Displays the port of the spanning-tree root.
priority Optional. Displays the priority of the spanning-tree root.
priority system-id Optional. Displays the priority and system-id of the spanning-tree root.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following is an example output using the show spanning-tree root command:
>enable
#show spanning-tree root
Root ID Root Cost Hello Time Max Age Fwd Dly Root Port
-------------------- -------------- ------------- ------------ -------------- ----------------
8191 00:a0:c8:b9:bb:82 108 2 20 15 eth 0/1