ADTRAN 1000R Series - Manual (Page 254)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 254
show mac address-table dynamic
Use the show mac address-table dynamic command to display all dynamic medium access control
(MAC) addresses learned by the AOS.
Variations of this command include the following:
show mac address-table dynamic
show mac address-table dynamic address
show mac address-table dynamic address interface
show mac address-table dynamic address interface
vlan
show mac address-table dynamic address vlan
show mac address-table dynamic interface
show mac address-table dynamic interface vlan
show mac address-table dynamic vlan
Syntax Description
address Specifies a valid 48-bit MAC address.
interface Shows information for a specific interface. Type show mac address-table
dynamic interface ? for a list of valid interfaces.
Specifies a valid slot/port interface ID (e.g., 0/1).
vlan Specifies a valid VLAN interface ID (1 to 4094).
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, and 2000 Series units.
Command History
Release 5.1 Command was introduced.