ADTRAN 1000R Series - Manual (Page 257)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 257
show mac address-table static
Use the show mac address-table static command to display all static medium access control (MAC)
addresses known by the AOS.
Variations of this command include the following:
show mac address-table static
show mac address-table static address
show mac address-table static address interface
show mac address-table static address interface
vlan
show mac address-table static address vlan
show mac address-table static interface
show mac address-table static interface vlan
show mac address-table static vlan
Syntax Description
address Specifies a valid 48-bit MAC address.
interface Shows information for a specific interface. Type show mac address-table
static interface ? for a list of valid interfaces.
Specifies any valid slot/port interface ID (e.g., 0/1).
vlan Specifies a valid VLAN interface ID (1 to 4094).
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1 Command was introduced.