ADTRAN 1000R Series - Manual (Page 1044)

Command Reference Guide PPP Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1044
bridge-group
Use the bridge-group command to assign an interface to the specified bridge group. This command is
supported on all Ethernet interfaces, PPP virtual interfaces, and Frame Relay virtual sub-interfaces.
Syntax Description
Assigns a bridge group number (range: 1 to 255).
Default Values
By default, there are no configured bridge groups.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 1.1 Command was introduced.
Functional Notes
A bridged network can provide excellent traffic management to reduce collisions and limit the amount of
bandwidth wasted with unnecessary transmissions when routing is not necessary. Any two interfaces can
be bridged (Ethernet to T1 bridge, Ethernet to Frame Relay sub-interface, etc.).
Usage Examples
The following example assigns the PPP interface to bridge-group 1:
(config)#interface ppp 1
(config-ppp 1)#bridge-group 1