ADTRAN 1000R Series - Manual (Page 632)

Command Reference Guide Ethernet Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 632
port-auth multiple-hosts
Use the port auth multiple-hosts command to allow multiple hosts to access an authorized port without
going through the authentication process. This command is only applicable when authentication is
port-based. Use the no form of this command to return to the default settings.
Syntax Description
No subcommands.
Default Values
By default, this command is disabled.
Applicable Platforms
This command applies to the NetVanta 1000 and 1000R Series units.
Command History
Release 10.1 Command was introduced.
Usage Examples
The following example enables multiple hosts to access an authorized port:
(config)#interface ethernet 0/1
(config-eth 0/1)#port-auth multiple-hosts