ADTRAN 1000R Series - Manual (Page 1146)

Command Reference Guide Tunnel Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1146
ip ospf network [broadcast | point-to-point]
Use the ip ospf network command to specify the type of network on this interface.
Syntax Description
broadcast Sets the network type for broadcast.
point-to-point Sets the network type for point-to-point.
Default Values
By default, Ethernet defaults to broadcast. PPP, Frame Relay, and tunnel default to point-to-point.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 Series units.
Command History
Release 3.1 Command was introduced.
Release 9.1 Command was expanded to include tunnel interfaces.
Functional Notes
A point-to-point network will not elect designated routers.
Usage Examples
The following example designates a broadcast network type:
(config)#interface tunnel 1
(config-tunnel 1)#ip ospf network broadcast