Dial-backup number – ADTRAN 1000R Series User Manual
Page 735
Command Reference Guide
ATM Sub-Interface Config Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
735
dial-backup number
Use the dial-backup number command to configure the phone number and the call type the router will
dial upon network failure. Multiple entries can be made for a sub-interface to allow alternate sites to be
dialed. For more detailed information on ATM dial-backup functionality, refer to the Functional Notes and
Technology Review sections of the command dial-backup call-mode [answer | answer-always | originate |
originate-answer | originate-answer-always]
.
Syntax Description
Specifies the phone numbers to call when the backup is initiated.
analog ppp
Specifies number connects to an analog modem.
digital-56k
Specifies number belongs to a digital 56 kbps per DS0 connection.
digital-64k
Specifies number belongs to a digital 64 kbps per DS0 connection.
Specifies the minimum number of DS0s required for a digital 56 or 64 kbps
connection (Range: 1 to 24).
Specifies the maximum number of DS0s desired for a digital 56 or 64 kbps
connection (Range: 1 to 24).
Specifies the ATM sub-interface (e.g., ATM 3.1) to use when originating or answering
using this number.
Default Values
By default, there are no configured dial-backup numbers.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 1.1
Command was introduced.
Release 8.1
ATM sub-interface was added.
Usage Examples
The following example configures the AOS to dial 704-555-1212 (digital 64 kbps connection) to initiate
dial-backup operation on this endpoint:
(config)#interface atm 1.1
(config-atm 1.1)#dial-backup number 7045551212 digital-64k 1 1 atm 3.1