Remote-alarm [rai – ADTRAN 1000R Series User Manual

Page 706

Command Reference Guide

T1 Interface Configuration Command Set

61200510L1-35E

706

remote-alarm [rai]

The remote-alarm command selects the alarm signaling type to be sent when a loss of frame is detected
on the T1 receive signal. Use the no form of this command to disable all transmitted alarms.

Syntax Description

rai

Specifies sending a remote alarm indication (RAI) in response to a loss of frame.
Also prevents a received RAI from causing a change in interface operational
status.

Default Values

The default for this command is rai.

Applicable Platforms

This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.

Command History

Release 7.1

Command was expanded to include the T1 interface.

Usage Examples

The following example enables transmission of RAI in response to a loss of frame:

(config)#interface t1 1/1

(config-t1 1/1)#remote-alarm rai