ADTRAN 1000R Series - Manual (Page 688)

Command Reference Guide SHDSL Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 688
equipment-type [co | cpe]
Use the equipment-type command to determine the operating mode for the SHDSL interface.
Syntax Description
co Use this option only in a campus environment when operating two SHDSL
network interface modules (NIMs) back-to-back. In this setup, configure the
master NIM to CO and the slave NIM to CPE.
cpe Use this option when interfacing directly with your service provider or when acting
as the slave NIM in a campus environment.
Default Values
The default for this command is cpe.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 3.1 Command was introduced.
Usage Examples
The following example changes the operating mode of the SHDSL interface to CO:
(config)#interface shdsl 1/1
(config-shdsl 1/1)#equipment-type co