ADTRAN 1000R Series - Manual (Page 1353)

Command Reference Guide Route Map Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1353
R OUTE M AP C OMMAND S ET
To activate the Route Map Interface Configuration mode, enter the route-map command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#route-map MyMap permit 100
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 32
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
match as-path on page 1354
match community [exact-match] on page 1355
match ip address on page 1356
match ip address prefix-list on page 1357
match metric on page 1358
set as-path prepend [ | last-as ] on page 1359
set comm-list delete on page 1360
set local-preference on page 1361
set metric on page 1362