Bridge-group Page 933
Page 933
Command Reference Guide
HDLC Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
933
bridge-group
Use the bridge-group command to assign an interface to the specified bridge group. Use the no form of
this command to remove the interface from the bridge group.
Syntax Description
Specifies bridge group number (1 to 255) specified using the bridge-group
command
Default Values
By default, there are no configured bridge groups.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 9.1
Command was introduced.
Functional Notes
A bridged network can provide excellent traffic management to reduce collisions and limit the amount of
bandwidth wasted with unnecessary transmissions when routing is not necessary. Any two interfaces can
be bridged (Ethernet to T1 bridge, Ethernet to Frame Relay sub-interface, etc.).
Usage Examples
The following example assigns the HDLC interface labeled 1 to bridge-group 1:
(config)#interface hdlc 1
(config-hdlc 1)#bridge-group 1