ADTRAN 1000R Series - Manual (Page 367)

Command Reference Guide Global Configuration Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 367
crypto ike
Use the crypto ike command to define the system-level local ID for IKE negotiations and to enter the IKE
Client or IKE Policy command sets.
Variations of this command include the following:
crypto ike client configuration pool
crypto ike local-id address
crypto ike policy
Syntax Description
client configuration pool Creates a local pool named the of your choice and
enters the IKE Client. Clients that connect via an IKE policy that
specifies this pool-name will be assigned values from this pool.
Refer to the section
IKE Client Command Set on page 1250 for
more information.
local-id address Sets the local ID during IKE negotiation to be the IP address of
the interface from which the traffic exits. This setting can be
overridden on a per-policy basis using the local-id command in
the IKE Policy (refer to
local-id [address | asn1-dn | fqdn |
user-fqdn] on page 1267 for more
information).
policy Creates an IKE policy with the of your choice and
enters the IKE Policy. Refer to
IKE Policy Command Set on page
1260 for more information.
Default Values
There are no default settings for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1 Command was introduced.
Usage Examples
The following example creates an IKE policy with a policy priority setting of 1 and enters the IKE Policy for
that policy:
(config)#crypto ike policy 1