Ip proxy-arp Page 1147
Page 1147
Command Reference Guide
Tunnel Configuration Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
1147
ip proxy-arp
Use the ip proxy-arp command to enable proxy Address Resolution Protocol (ARP) on the interface. Use
the no form of this command to disable this feature.
Syntax Description
Defines the proxy ARP IP address in dotted decimal notation (for example:
192.22.73.101).
Specifies the subnet mask that corresponds to the listed IP address.
Default Values
By default, proxy-arp is enabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 9.1
Command was introduced.
Functional Notes
In general, the principle of proxy ARP allows a router to insert its IP address in the source IP address field
of a packet (if the packet is from a host on one of its subnetworks). This allows hosts to reach devices on
other subnetworks without implementing routing or specifying a default gateway.
If proxy ARP is enabled, the AOS will respond to all proxy ARP requests with its specified MAC address
and forward packets accordingly.
Enabling proxy ARP on an interface may introduce unnecessary ARP traffic on the network.
Usage Examples
The following enables proxy ARP on the tunnel interface:
(config)#interface tunnel 1
(config-tunnel 1)#ip proxy-arp