ADTRAN 1000R Series - Manual (Page 926)

Command Reference Guide HDLC Command Set
61200510L1-35E Copyright © 2005 ADTRAN 926
HDLC C OMMAND S ET
To activate the HDLC mode, enter the interface hdcl command at the Global Configuration mode prompt.
For example:
>enable
#configure terminal
(config)#interface hdlc 1
(config-hdlc 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#>
on page 28
description on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy on page 928
alias link<“text”> on page 931
bandwidth on page 932
bridge-group on page 933
crypto map on page 934
dial-backup commands on page 936
dynamic-dns [dyndns | dyndns-custom | dyndns-static]
on page 952
fair-queue on page 954
hold-queue out on page 955
ip commands begin on page 956
keepalive on page 974
lldp receive on page 975
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive] on page 976