ADTRAN 1000R Series - Manual (Page 409)

Command Reference Guide Global Configuration Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 409
ip dhcp-server pool
Use the ip dhcp-server pool command to create a DHCP address pool and enter the DHCP pool. Use the
no form of this command to remove a configured DHCP address pool. Refer to the section DHCP Pool
Command Set
on page 1327 for more information.
Syntax Description
Identifies the configured DHCP server address pool using an alphanumeric string
(up to 32 characters in length).
Default Values
By default, there are no configured DHCP address pools.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 2.1 Command was introduced.
Functional Notes
Use the ip dhcp-server pool to create multiple DHCP server address pools for various segments of the
network. Multiple address pools can be created to service different segments of the network with tailored
configurations.
Usage Examples
The following example creates a DHCP server address pool (labeled SALES) and enters the DHCP server
pool mode:
(config)#ip dhcp-server pool SALES
(config-dhcp)#