ADTRAN 1000R Series - Manual (Page 248)

Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 248
show mac address-table
Use the show mac address-table command to display all static and dynamic entries in the medium access
control (MAC) address table for all virtual local area networks (VLANs) and physical interfaces.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, and 2000 Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following is sample output from the show mac address-table command:
>enable
#show mac address-table
Mac Address Table
------------------------------------------
Vlan Mac Address Type Ports
1 aa:bb:ee:d1:c2:33 STATIC eth 0/18
1 00:00:00:00:00:00 STATIC CPU
2 00:90:2b:7d:30:00 DYNAMIC eth 0/1
2 00:a0:c8:00:8e:a6 DYNAMIC eth 0/1
2 00:a0:c8:00:8f:ba DYNAMIC eth 0/1
2 00:a0:c8:00:8f:73 DYNAMIC eth 0/1
2 00:a0:c8:00:00:00 DYNAMIC eth 0/1
2 00:a0:c8:01:ff:02 DYNAMIC eth 0/1
2 00:a0:c8:01:09:d3 DYNAMIC eth 0/1
2 00:a0:c8:01:13:34 DYNAMIC eth 0/1
2 00:a0:c8:01:14:4a DYNAMIC eth 0/1
2 00:a0:c8:03:95:4b DYNAMIC eth 0/1
2 00:a0:c8:05:00:89 DYNAMIC eth 0/1