ADTRAN 1000R Series User Manual
Page 256
Command Reference Guide
Enable Mode Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
256
show mac address-table interface [
| vlan
Use the show mac address-table interface command to display information regarding medium access
control (MAC) address table entries specific to a certain interface.
Syntax Description
Shows information for a specific interface type. Type show mac address-table
interface ? for a list of valid interfaces.
Shows address-table information related to a specific interface (e.g., eth 0/1).
vlan
Shows address-table information related to a specific VLAN. Specifies a valid
VLAN interface ID (1 to 4094).
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, and 2000 Series units.
Command History
Release 5.1
Command was introduced.
Usage Examples
The following is an example of the show mac address-table interface eth 0/1 command displaying MAC
address-table entries specifically on Ethernet 0/1:
>enable
#show mac address-table interface ethernet 0/1
Mac Address Table
Vlan
Mac Address
Type
Ports
2
00:90:2b:7d:30:00
DYNAMIC
eth 0/1
2
00:a0:c8:05:00:ac
DYNAMIC
eth 0/1
2
00:a0:c8:05:00:ad
DYNAMIC
eth 0/1
2
00:a0:c8:05:00:c2
DYNAMIC
eth 0/1
2
00:a0:c8:05:01:6e
DYNAMIC
eth 0/1
2
00:a0:c8:09:95:6b
DYNAMIC
eth 0/1
2
00:a0:c8:0a:2d:7c
DYNAMIC
eth 0/1
Total Mac Addresses for this criterion: 10