ADTRAN 1000R Series - Manual (Page 728)

Command Reference Guide ATM Sub-Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 728
dial-backup backup-delay
Use the dial-backup backup-delay command to configure the amount of time the router will wait after the
failure condition is recognized before attempting to backup the link. Use the no form of this command to
return to the default value.
Syntax Description
Specifies the delay period (in seconds) a failure must be active before the AOS
will enter backup operation on the interface (valid range: 10 to 86,400 seconds).
Default Values
By default, the dial-backup backup-delay period is set to 10 seconds.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 1.1 Command was introduced.
Release 8.1 ATM sub-interface was added.
Usage Examples
The following example configures the AOS to wait 60 seconds (on an endpoint with an active alarm
condition) before attempting dial-backup operation:
(config)#interface atm 1.1
(config-atm 1.1)#dial-backup backup-delay 60