ADTRAN 1000R Series - Manual (Page 1109)

Command Reference Guide Tunnel Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1109
T UNNEL C ONFIGURATION C OMMAND S ET
To activate the Tunnel Configuration mode, enter the interface tunnel command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface tunnel 1
(config-tunnel 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#>
on page 28
description on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy on page 1110
bandwidth on page 1113
crypto map on page 1114
dial-backup commands begin on page 1116
dynamic-dns [dyndns | dyndns-custom | dyndns-static]
on page 1132
ip commands begin on page 1134
keepalive on page 1151
lldp receive on page 1152
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive] on page 1153
mtu on page 1155
tunnel checksum on page 1156
tunnel destination on page 1157
tunnel key on page 1158
tunnel mode gre on page 1159
tunnel sequence-datagrams on page 1160
tunnel source [ | ] on page 1161