ADTRAN 1000R Series User Manual
Page 266
Command Reference Guide
Enable Mode Command Set
61200510L1-35E
Copyright © 2005 ADTRAN
266
show port-security [address | interface
detailed
Use the show port-security command to display port security information.
Syntax Description
address
Displays a list of secure medium access control (MAC) addresses for all
interfaces currently configured for port security.
interface
Filters the output to include only information for a particular interface.
port-expiration
Displays the ports currently participating in port expiration and the amount of time
left until the port is shutdown.
detailed
Displays information for all interfaces, even if not configured for port expiration.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 8.1
Command was introduced.
Usage Examples
The following displays all secure MAC addresses related to the Ethernet 0/1 interface:
>enable
#show port-security interface eth 0/1 address
VLAN Mac Address Type of Entry Interface Remaining Time
--------------------------------------------------------------------------------------------------------------
1 00:a0:c8:0a:c6:4a Dynamic-Secure eth 0/1
--
1 00:a0:c8:0a:c6:4b Dynamic-Secure eth 0/1
--
--------------------------------------------------------------------------------------------------------------
Dynamic Address Count: 2
Static Address Count: 0
Sticky Address Count: 0
Total Address Count: 2