ADTRAN 1000R Series - Manual (Page 569)

Command Reference Guide BRI Interface Configuration Command set
61200510L1-35E Copyright © 2005 ADTRAN 569
bonding txdeq-timer
Use the bonding txdeq-timer command to specify the value (in seconds) for the network delay
equalization timeout. Use the no form of this command to return to the default value.
Syntax Description
Specifies the number of seconds the endpoint allots for attempting to equalize the
network delay between bearer channels before considering the bonding
negotiation a failure.
Default Values
By default, the bonding txdeq-timer value is 50 seconds.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, and 4000 Series units.
Command History
Release 1.1 Command was introduced.
Functional Notes
Specifies the length of time both endpoints allot to attempt to equalize the network delay between the
bearer channels before deciding the bonding call has failed.
Usage Examples
The following example defines a bonding txdeq-timer value of 80 seconds:
(config)#interface bri 1/2
(config-bri 1/2)#bonding txdeq-timer 80